This paper has substantiated the prospect of modeling the processes of separating grain mass into fractions as one of the tasks in the production of high-quality seed material. It has been determined that this could optimize the parameters of separation processes and design new working surfaces for its implementation. It is noted that modeling should take into consideration the influence of the structural and kinematic parameters of grain cleaning machines, the physical and mechanical properties of raw materials, the intralayer processes and forces. The reported theoretical study has improved the mechanical- mathematical model of grain mass separation in a pseudo-fluidized bed according to its density. The model establishes a relationship between the effective coefficient of dynamic viscosity and the density of particles in the discrete and continuous phases and the volumetric concentration of discrete phase particles. At the same time, the porosity of a fluidized bed has been accounted for, as well as the longitudinal and transverse angles of inclination of the base surface to the horizontal plane, the amplitude and frequency of oscillations of the particles of the continuous phase; the direction angle of oscillations relative to the perpendicular to the base surface. The adequacy of the improved mechanical-mathematical model has been confirmed by comparing the experimental and theoretical results of grain mass fractionation modeling. It was found that the differences in the density values of the separated fractions of GM did not exceed 7 - 8 %, that is, they were within the margin of error. It has been established that the improved model of grain mass separation in a fluidized bed could be used to determine the rational values for the parameters of a pneumatic sorting table that is used for the fractionation of the corresponding seed material. The initial data, in this case, are the density of the continuous and solid phases of grain mass, the friction coefficient of the seeds, and the equivalent radius of the particle. The result of modeling is the rational values of the amplitude and oscillation frequency of the working surface of the pneumatic sorting table, and the angles of inclination of the working surface.

 Наукова періодика України 

---

Додаткова інформація про автора(ів) публікації:
(cписок формується автоматично, до списку можуть бути включені персоналії з подібними іменами або однофамільці)

• Бредихін Вадим Вікторович (технічні науки)
• Пак Андрій Олегович (технічні науки)

  Якщо, ви не знайшли інформацію про автора(ів) публікації, маєте бажання виправити або відобразити більш докладну інформацію про науковців України запрошуємо заповнити "Анкету науковця"